Lot Distribution Contribution - Troubleshooting

Troubleshooting

Message

Cause

What to do

Consumption has been posted against this lot, so to close it you must run the action "Distribute Contribution" so that all consumption entries are properly accounted for.

Posting Status was set to Completed (Closed) by hand.

Use Distribute Contribution.

BC Inv. Production Posting of Lot x must not be blank.

The lot has no posting type.

Set BC Inv. Production Posting on the lot.

Nothing found to distribute for Lot x. / No production was found for Lot x to distribute upon.

Consumption but no output in the lot (or the stage).

Post the output first, or use Close without Production

There is no production to distribute Trade Item x-y upon. Check if the Contribution Raw Material matches between the consumption and production, or set the "Consumption Distribution per" field on the Lot to "Lot".

Distribution per Contribution Raw Material, and no product of the lot is made of this raw material.

Check Contrib. Raw Mat. No. on the products, or set Consumption Distribution per = Lot.

Item x does not have a Weight Unit of Measure.

A trade item has no weight unit.

Set the item's Weight Unit of Measure.

Revaluation = Failed (see Comments) on the lot

The value distribution stopped, for example a Value Based product with no unit cost ratio.

Read the lot's comments, correct, and run Revaluate Lot or Distribute Contribution again.

Lot x is set to "Close without Production". Production to this lot is not allowed.

Output was posted to such a lot.

Post the output to another lot.

Item Ledger Entries have already been posted to this Lot. Posting type cannot be changed. / … consumed to this Lot …

BC Inv. Production Posting was changed after posting.

Not possible once posted.

Lot cannot be reopened if it was "Closed without Production".

 

By design.

Consumption has been distributed and posted to BC-inventory. You must credit all consumption before changing back to Raw Material distribution.

Consumption Distribution per changed back from Lot.

Credit all consumption first, or keep Lot.

Consuming from Lot: "a", (Stage: …) into Lot: "b", (Stage: …) creates a circular reference …

The consumption would close a loop between lots.

Consume from another lot. The page Consumption Connections shows the connections.

Consumed to Stage must be blank (in all lines).

Lot Stages Distribution with Consumed to Stage filled in.

Clear Consumed to Stage on the lines.

Trade Item x y has less quantity than recorded.

The journal lines take more than the trade item has.

Correct the quantities.

No lines were selected for updating. / Unit Cost not fetched from Item Card(s).

Fetch Unit Cost with no line selected, or answered No.

Select lines and confirm.

You are not allowed to Lock/Unlock Lot Products Stages.

 

Set Lock Lot Products Stages on the user profile.

BOM Component Location Code must have a value in Stock Center … (on the output trade item)

Location Mandatory and no component location.

Fill in the location on the BOM line or the stock center.

Notification: "Lots with Quantity Distribution errors: n"

Close Lots for Cost Adjustments could not distribute some lots.

See the error page at the end of the batch job; the lots are open again.